Products infomation

HOME > Products infomation > BELT CONVEYOR PROTECTION > CHUTE SWITCH > 

BELT CONVEYOR PROTECTION

CHUTE SWITCH

For Plugged Chute Lateral Pressure Detection

Detecting method

type

Sensitivity

14.7 to 24.5N (1.5kg to 2.5kg)
(At swing plate tip) 

Chute Switch is used in order to stop a belt conveyor instantly when a transported load clogs a junction chute of the conveyor. This switch is so constructed that it should be mounted on the side wall of junction chute by use of a square hole cut out in the wall. When the load clogs the junction chute and then the swing plate of the Chute Switch is pushed back with the pressure of accumulated load, the Chute Switch sends out an emergency stopping signal.   

 

カタログPDF

Page top